Sprayer failure and troubleshooting

In the use of sprayer will always encounter a bad spray effect, the switch leaks or does not move, leaks at the connection site and other faults, then how to eliminate these faults?

Inadequate spray pressure leads to poor atomization: If the rocker is toggled more than 15 times during spraying and the pressure in the barrel has not reached the working pressure, the vegetable farmer should first check whether the water inlet ball valve has been thrown away by debris, resulting in insufficient air pressure. The atomization effect. The inlet valve can be removed, if there is, then use a rag to clean; if the spray pressure is still insufficient, you should check whether the air chamber damage inside the leather cup, if damaged, you need to replace the new skin; if sealed due to the connection site If the air leakage is caused by the unmounted or broken rings, seals should be added or replaced.

The liquid spray does not fog: The obstruction of the inclined hole of the sprayer body by the dirt is one of the most common factors causing the spray to fail to form fog. The vegetable grower can remove the spray head and blow it backwards from the spray hole to remove the jammed dirt. If the nozzle hole is blocked, the cleaning nozzle hole can be dismantled. However, it is not allowed to use a wire or other hard object to inject the hole to prevent the hole from expanding and affect the quality of the spray. If the screen is blocked by the filter or the ball of water is caught by the dirt. The filter should be cleaned and the dirt that left the ball should be cleaned.

If the switch cap is not tightened, the switch cap should be tightened. If the switch is worn due to the washer on the switch core, replace the gasket. The switch does not move much because it is placed for a long time, the switch core is etched by the medicament and sticks. The vegetable grower should put the switch in kerosene or diesel oil for a period of time, and then remove and clean it.

Leakage at the joint: If the joint is loose, tighten the nut. If the washer is not flat or damaged, place the washer flat or replace the washer.