Various types of faucets have different daily maintenance methods

The faucet is indispensable in our daily life. Different types of faucets have different maintenance. Below we will explain how to maintain the faucet.

Basin faucet

When purchasing a single-handle basin faucet, you should pay attention to the diameter of the water outlet. Now, except for the washbasin of TOTO, most of the products belong to the national standard. Most of GROHE's Basin Faucets are made of hard pipe, so you should pay attention to the height of the water inlet. The 35 working points from the basin are most suitable. When installing, be sure to choose the special Angle Valve of GROHE, and the angle valve must be fixed with the hot and cold water pipe of the wall outlet. When you find a distance between the angle valve and the water pipe on the faucet, go to your current store to purchase the special extension tube of the GROHE faucet to connect.

Remember, don't use other water pipes to connect, because if the water pressure is too large, it will easily fall off and leak, causing damage to you. If the inlet pipe is too long to exceed the outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, bend it to the position you need as needed. Remember: Don't talk hard and bend to 90 degrees or more than 90 degrees. When installing the basin to remove water, please don't forget to buy the small interface of the faucet (the faucet is shorted).

Shower, bathtub faucet (wall hanging)

When you have purchased a shower, bathtub, or wall faucet, you can choose the right level to bury the water pipe. The spacing between the hot and cold water pipes must be 15 working minutes. Before installation, you must not forget to rinse the water pipe to avoid excessive water quality and damage to the faucet. If the elbow between the faucet and the wall joint is too long, cut off the part of the 4-point wire and remember that the 6-point connection with the faucet does not seem to be tangled.

Concealed shower, bathtub faucet

After purchasing a concealed faucet, it is generally necessary to pre-bury the faucet of the faucet in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be buried. The plastic protective cover of the valve plug should not be easily removed when it is buried, so as not to damage the valve core in the case of cement and other chores. In addition, when pre-burying the valve core, you should also pay attention to the up and down and left and right directions of the valve core to avoid the valve core being buried.

Shower

When you have installed the shower and bathtub faucet, don't forget to filter the filter inside the shower when you need to install the shower. When installing a shower, the water pressure must not be too high, generally 1 - 3 kg is best, can not exceed 5 kg. If the water pressure is too high, the water flow limiter in the faucet spool can also be opened to reduce the water pressure, and the water saving effect can also be achieved.

Thermostatic faucet

Before installing the constant temperature faucet, please check if the water pipe is left hot and cold right. Remember not to connect the hot and cold water pipes incorrectly, so as to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat.

Routine maintenance

In the process of using the faucet, it is necessary to frequently maintain and clean the scale on the surface of the faucet and the water sand in the faucet to protect the chrome-plated layer on the faucet surface as bright. Do not use a rough towel or cloth to wipe the faucet, so as not to scratch the chrome layer, and do not touch the faucet with acid and alkaline items to avoid damaging its brightness.