The basin faucet is one of the most frequently used hardware in the family, because it is prone to problems due to frequent use. Once there is a problem with the faucet, it is inevitable to disassemble or even overhaul and replace it. After confirmation, the installation process will be involved. In fact, the installation and disassembly of the basin faucet are relatively simple, but many people still don't understand the specific operation steps. This article will introduce you to a related issue about the installation and removal of the basin faucet.
Installation part 1. Take out the packaged basin faucet and check whether the accessories are complete before use. Before installation, the area around the installation port should be cleaned to ensure that there is no dirt in the water supply pipe and keep the water inlet pipe clean. Wear gloves when installing if you don't want to scratch the faucet.
2. Take off the rubber gasket on the basin faucet, insert the water inlet pipe and tighten it. After the first air intake hose passes through the threaded joint, the air intake end of the second air intake hose passes through the threaded joint and is screwed into the air inlet. During the installation process, pay attention to control the direction, apply force evenly, and then tighten the screw joint.
3. Put the two water inlet hoses into the rubber pad, cover and tighten the lock nut that fixes the faucet, and then tighten the sleeve. The positions of the two water inlet hoses and the Angle Valve joints should be tightened separately, but it is recommended not to use too much force to avoid deformation or twisting. So in three steps, the basin faucet is installed.
The above are the installation steps of the basin faucet, and then explain the disassembly steps. 1. Use a wrench to separate the water inlet pipe from the hose. A control component is required. It's not good if you accidentally break the tube. If the water inlet pipe at home is aAn open pipe, you can hold the water pipe with one hand and twist it with a wrench with the other hand when separating, which makes separation more convenient.
2. Remove the fixed basin faucet firmware, allowing you to take the faucet easily. Usually this process is very simple, but if the pot has been used for a long time, the hose will appear brittle, or the hardware will be rusted, this disassembly process will be more troublesome. You can put a few drops of engine oil on the rusty place, and then turn on the tap. If you can't unscrew it, you can try to remove the rust with a saw, and then unscrew the faucet. The above are related issues about the installation and removal of the basin faucet. I hope this article can be helpful to you.
Jianfa Sanitary Ware is a factory-type enterprise with a series of professional equipment to provide customers with the best OEM/ODM services. Our products mainly are Basin Faucets, Kitchen Faucets, Shower Faucets and other Bathroom Accessories.For more information, please contact us: Tel :+86-0750-2713538 Mobile Phone :+8613822427897 Email :raymondtam754@gmail.com
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
We will contact you immediately
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
